Countersink COARSE 90 Degree

Tip: To zoom in, press down on the image above and move your finger.
  • Countersink COARSE 90 Degree
  • Countersink COARSE 90 Degree
Inc VAT
Ex VAT

Countersink COARSE 90 Degree

[RF-10C]
Small Rotary
Rotary Countersink Coarse Grit, 11mm 90 Degree.  Shaft / arbor 3.1 mm (1/8").
 

(not recommended for use on metal)

 
Our Rotaries have an integral arbor, enabling them to be used in reversible drive tools. 
They allow the user to cut a wide range of materials quickly and cleanly leaving an excellent finish. All rotaries are ideal for routing, shaping and removing materials without tearing or clogging.
Use on all Woods, Glass Fibre, Carbon Fibre, PCB, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Ceramics, Stone, Brick etc.
Excellent on Perspex, Plexiglass, Lexon, use below 10,000 RPM and they will not melt, crack or chip them. (not recommended for use on metal)
Note Rotaries should be fully inserted in to the chuck and tightened before using. Maximum RPM 20,000 Low - Medium.
SAFETY:- Always wear protective goggles when using Rotary Tools.
IMPORTANT:- Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.

 
 
Quantity:
Quantity:
£9.58
Proudly Supplying Tungsten Carbide Grit Abrasive Tools to...

Our website uses cookies so that we can provide a better service. Continue to use the site as normal if you're happy with this, or find out how to manage cookies.   x