Rotary Rod FINE 4 mm

Tip: To zoom in, press down on the image above and move your finger.
  • Rotary Rod FINE 4 mm
  • Rotary Rod FINE 4 mm

Rotary Rod FINE 4 mm

Small Rotary
Rotary Rod Fine finishing Grit, 4 mm.  Shaft / arbor 3.1 mm (1/8").
Finish shapes and work thin, fine materials.
Our Rotaries have an integral arbor, enabling them to be used in reversible drive tools. They allow the user to cut a wide range of materials quickly and cleanly leaving an excellent finish.

The Drum RF3 and Pancake RF4 cut on the end face as well as the sides.  All rotaries are ideal for routing, shaping and removing materials without tearing or clogging. RF1C and RF6C will make there own pilot hole in material, which can then be enlarged.

Note  Rotaries should be fully inserted in to the chuck and tightened before using.  Maximum RPM 20,000 Low - Medium.

Remember   Always wear protective goggles when using Rotary Tools.

Important   Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.

Perma-Grit® Tools will cut:-  All Woods, Glass Fibre, Carbon Fibre, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Brass, Copper, Aluminium, Ceramics, Stone, Horn, Antler etc.

"Lubricate with WD40 oil or chalk if using on aluminium to reduce loading”

(not recommended for use on metal)
Proudly Supplying Tungsten Carbide Grit Abrasive Tools to...

Our website uses cookies so that we can provide a better service. Continue to use the site as normal if you're happy with this, or find out how to manage cookies.   x